Advertisements

Monthly Archives: September 2013

1971 Honda CB350 Cafe Racer Project – Episode 7: Getting There…

First, let me say that I am almost there… Then, let me add that it is one thing after another! The bike is almost ready to hit the road. Until yesterday I had power to all systems and it was turning over and idling nicely. I had gas overflow running out of one of my carbs so I started the day by adjusting the float to limit the gas inflow. It all went downhill from there. Prior to messing with the float the bike would idle nicely and would rev, but not beyond about 2800 rpm. I thought this was a timing issue but wanted to stop the gas overflow prior to adjusting the timing. Once I adjusted the float I stopped the overflow, but then the bike was not getting enough gas to rev at all. Instead it would die every time I gave it gas. I checked the float bowl on the suspect carb and it was not getting gas at all so i readjusted the float and tried again. Same situation. I put it down and tackled the turn signal wiring to clear my head. I had power to all turn signals but they would not blink. They are on steady. I switched wiring around and around with no success. The headlight works perfectly bur no signal blink. The other problem is that the tail light is on but the brake light will not register. If I turn the key to position 2 then the brake light is on all the time. Something in the wiring is not right. Frustrated I turned back to the carb problem, I was just beginning to mess with the air gas mixture when all power to the bike was lost! The battery has juice but I get nothing anywhere. I checked the starter solenoid with my continuity tester and it is completely dead. I now have to swap out the solenoid from the parts bike to see if this is the culprit. Meanwhile here is what the bike looks like before I start beating on it with a hammer…

Image

Image

Image

Image

Image

Image

Advertisements